Comfy humidity mode helps you automatically change your AC settings if room humidity goes above or falls below a pre-set value helping you save energy with lots of convenience. To set comfy humidity mode for your Air-Conditioner, follow the instructions mentioned below:
Step 1: On the Home screen, tap on the Air-Conditioner / Heat Pump you want to set comfy
humidity mode on.
Step 2: Tap on ‘eSaver’ in the navigation bar.
Step 3: Tap on 'Comfy Mode'.
Step 4: Toggle the slider to enable Comfy, as shown in the red box.
Step 5: Tap on 'Humidity' to set 'Comfy Mode' for humidity.
Step 6: Select what actions to perform if the humidity falls below or goes above the set range
e.g. turning the AC off or on, changing its mode, temperature and fan speed helping it
get back into the preferred humidity range.
Step 7: Tap 'Done' to enable it. Once the device triggers the defined comfy humidity mode
actions you will get a notification in your app timeline.
Step 8: You can turn Comfy Mode On/Off from the device control screen. Tap on the 'Up' arrow icon at the bottom of the control screen.
Step 9: On the pop-up navigation bar, tap on 'Comfy' to toggle it On or Off. Currently it is turned 'Off', shown by the greyed out icon.
Step 10: To turn it 'On', tap on the Comfy icon, and it will turn white. It is now turned 'On'.
Comments
1 comment
Comfy Mode is good. Like that. However there are missing things:
- Comfy mode can not be temperature range.
It needs to be set as a single temperature (e.g. 75F), but then user should be able to set the temperature swing to be either 1,2,3,4 degrees may be up to 10 degrees.
- Comfy Mode temperature setting can not just be ONE. Period.
It needs to be similar to any thermostat where temperature is different at given time of the day.
Should be able to set different comfy mode for at least 4 times a day. (Even better would be just as many as you want to add)
Basically, get rid of comfy mode, instead introduce "Program" like an actual smart thermostat.
- Separate comfy modes for summer(ac)/winter(heat pump).
Temperature can not be same for these operating modes and I do not want to change this each season.
So basically Cool/Heat programs.
Moreover, Cool/Heat program should have associated louver position setting as well (which is unique thing for Split units).
Please sign in to leave a comment.